The standard of decoration is getting higher and higher, especially in the treatment of detail, such as the treatment of ceramic tile crevice. In the past, white cement was often used to fill the gap between ceramic tiles, but now most people use stitching agent, it is not only beautiful, but also has more powerful performance than other materials. So what do you do with the ceramic tile seams? What are the points for attention in the construction of ceramic tile joint? The editor will share these questions with you, looking forward to helping friends in need.

How to make a beautiful sew of ceramic tile

Usually the tile sewing is done by the master, so many people think it is a very professional, very complex thing. As a matter of fact, it is not so difficult to do good seams for ceramic tiles. We can master them through learning. Before construction, we need to prepare the appropriate tools and materials: stitching agent, embossing paper, knuckles, silicone gun, edge pressing ball, knife, sewing cone, brush.

How to do the ceramic tile of the ceramic tile

不少人都搞不清楚何时可以做美缝，其实做美缝最好的时间节点是刷漆玩或者贴完壁纸后。大家在施工前，还应对地面进行清扫，然后处理瓷砖缝隙，用美缝锥把瓷砖缝先铲出一个2毫米以内深的凹槽，这样美缝剂能够足够的多，粘贴面面积积平面足够的打，不容易脱落，太浅容易脱落。

How to make three beautiful seams of ceramic tile

After all the work of the earlier stage is done, we can begin to fill in the joint agent. And then, the glue gun is put on the glue gun, the waste material is extruded, and then the rubber nozzle is installed, and a side cut is appropriately processed by the American working knife according to the size of the seam. Since there is air in front of the nozzle, or the mixing is not uniform, the length of about 40 cm is not usable, and the extrusion is discarded when the waste is discarded. After air-drying, the blade can be used to remove a small amount of residual hairspray. The great work has been done.

Matters needing attention in construction of ceramic tile beauty joint

Beautiful seams seem simple, but contain a lot of knowledge, need to pay attention to a lot of matters. In order to ensure the effect of the stitch, we should grasp the time point of construction and suggest that it should be carried out after painting or wallpaper. This is because after the tiles have been pasted, the construction treatment of batching plaster, putty, paint and so on the wall surface will begin, and in the course of the top treatment of the wall, the ground will easily be dirty. Therefore, it is recommended that the time node of the floor tile seam should be placed on the top of the wall after finishing the treatment (paint or wallpaper, etc.). Ceramic tile joint construction points for attention some owners are more urgent, as soon as the United States seam began to mop the floor, sanitary. Remember not to mop the ground or engage in water within 24 hours after the completion of the construction. In addition, it is best to paste beautiful paper on both sides of ceramic tile during construction, oil-bearing material of the sewing agent, cleaning more painstakingly.